• Startseite
• ford 303-1611
• [JTC-6805] CRANKSHAFT PULLEY REMOVER/INSTALLER FOR FORD VEHICLES – JTC Auto Tools

[JTC-6805] CRANKSHAFT PULLEY REMOVER/INSTALLER FOR FORD VEHICLES – JTC Auto Tools

4.6 (289) · € 465.99 · Auf Lager

The Ford crankshaft pulley is specially designed to remove and install the crankshaft pulley, in order to replace the timing belt. Application: Ford

The VW, Audi crankshaft pulley holding tool is specially designed to hold the crankshaft pulley for removal and installation on the crankshaft center

[JTC-4141] CRANKSHAFT PULLEY HOLDING TOOL FOR VW/AUDI – JTC Auto Tools

Laser Tools 8394 Crankshaft Pulley Removal Tool - for Ford Ranger

Crank Bolt Installation Tool

The Volvo fuel injector remover is specially designed for correct removal of the injection nozzles with the slide hammer. Application: 1.0L, 2.0L

[JTC-6628] FUEL INJECTOR REMOVER FOR FORD/VOLVO VEHICLES – JTC Auto Tools

This tool is designed to hold the crankshaft pulley while loosening or tightening the centre screw. To tighten crankshaft pulley by 2 screws (M8 x

CRANKSHAFT Pulley Holder Compatible with Toyota, Lexus,Corolla Highlander CRANKSHAFT Remove Tool by JTC 4013

JTC-6805] CRANKSHAFT PULLEY REMOVER/INSTALLER FOR FORD VEHICLES

JTC-4438] CRANKSHAFT PULLEY HOLDING TOOL FOR FORD DURATEC – Techno

Engine Series – JTC Auto Tools

The Fuso crankshaft front oil seal installation tool is used for installing the crankshaft front oil seal. Application: Fuso Euro 5 lift cars / Iveco

[JTC-4342] FUSO CRANKSHAFT FRONT OIL SEAL INSTALLATION TOOL – JTC Auto Tools

The Ford crankshaft pulley holding tool is used for preventing the crankshaft from rotating when releasing or tightening the crankshaft pulley

[JTC-4524] CRANKSHAFT PULLEY HOLDING TOOL FOR FORD VEHICLES – JTC Auto Tools

*Specially designed to hold the crankshaft pulley while they pulley retaining bolt is loosened/tightened *Compatible With Ford 1.8, 2.0 Duratec Petrol

Crankshaft Pulley Holding Tool, Crank Pulley Holder Socket Wrench Compatible with Volvo Ford 1.8 2.0 2.3 16V by JTC 4438

Engine Series – JTC Auto Tools

JTC-4722] CAM/CRANK SHAFT SEAL PULLER – JTC Auto Tools

Engine Series – JTC Auto Tools

․Special design to remove the front pulley from the crankshaft. ․Applicable:VW,AUDI 4 and 5 cylinder engines.

CRANKSHAFT Pulley Remove Tool Set for VW,Audi by JTC 4745